THM 4L60-E - Push-In Cooler Line Fittings

CHANGE: Beginning at the start of production for 1996 models, all “C” and “K” Trucks and “G” Vans were built with a new design “Push-In” cooler line fittings for the transmission (See Figure 1). Get more hot car tools launch x431 diagun and CReader V from vtoolshop.

REASON: Ease of installation at the Truck Assembly Plants.

PARTS AFFECTED:

VEHICLE COOLER LINES - Modified oil cooler lines to accommodate the new design “Push-In” transmission cooler line fittings.

NOTE: General Motors recommends that the retaining “Clip” in the new design cooler line fittings be replaced every time that the cooler line is removed.

SERVICE INFORMATION:

Cooler Line Fitting (5/16” Lines) ............................................................................. 8637742

Cooler Line Fitting (3/8” Lines) ............................................................................... 865 1654

Cooler Line Fitting (Push-In) ................................................................................. 24205 102

Cooler Line Fitting Retaining Clip (Push-In). ........................................................ 24205 103